Service manual DW Outdoor
23
Service and installation
Rear motor compartment
Side panels
Undo the screws in the side
panel that attach to the cross
support.
Next undo the screws in
the back cover of the motor
compartment. Angle out the
side panels of the casing and
open the back cover.
NOTE:
The seals in the
bushings for the inlet and
outlet hoses, as well as for
the power cable, may need
replacing. Make sure you
have new sealing kit on hand
before starting any work.
Undo the screw in the side
panel mount in the rear
upper corner.
Undo the screw in the cross
support at the rear of the
machine.
Next undo the screws in
the back cover of the motor
compartment.
The two side panels of the casing only need to be removed when you need to access the
machine’s forward motor compartment and when you need to create more space for servicing
the machine (see the ”Increased working space during service” section). The air gap is located
inside the right side panel..
Finally, open the door and
undo the screws holding the
side panel in place from the
inside.
Angle out the top edge of
the side panel and then lift
the side panel to free it from
the catches.
The slots in the bottom of
the side panel keep it in
place.
