Service manual DW Outdoor
22
Service and installation
Disassembling and reassembling the machine’s casing
In order to access the machine’s components, fi rst we need to disassemble its casing, either in part
or in full. Once servicing is completed, reassemble the casing with care so that it is properly resealed.
We recommend wearing gloves and using caution when removing the stainless steel panels that
make up the casing of the machine. The panels, once removed, may have unfi nished edges that
could be sharp.
Be careful not to damage the casing and seals during disassembly and reassembly! It’s a good
idea to have new seals for the rear motor compartment on hand in case any of them get damaged
and need replacing.
• 88 015 03 – Sealing kit DW Outdoor
*
Top cover
Upper and lower rear panels
Then lift and slide the top
cover forward 1 cm (1/2”)
or so to free the catches on
the side panels of the casing.
Lift the top cover from the
machine.
Remove the hose holder/high
loop and undo the top cover
screws at the rear of the
machine.
Also undo the screws running
through the top edge of the
cleaning compartment from
inside the machine.
Undo the screws in the rear
panel and lift the bottom
edge of the panel to free the
catches from the slots in the
side panels. Remove the rear
panel from the machine.
Undo the screws in the lower
back panel.
