15
CONDENSATION WATER
Connection to floor drain
The drying cabinet is supplied from the factory with a hose to the detachable water
tank. To change to discharging condensation water to a floor drain, proceed as
follows:
1
Carefully pull the upper part of
the hose out around 2-3 cm.
2
Cut off the hose in the middle of
the opening.
3
Assemble the new drain hose
with the nipple provided in the
assembly kit, as illustrated. Pull
the hose on without hose clips.
4
Place the drain hose in one of the
recesses in the panel so there is
no risk of it being crushed.
5
Run the drain hose to the drain.
6
If the drain is higher than the
outlet of the cabinet, make sure
that the hose runs in an arc down
to the floor and forms a water
trap. There is otherwise a risk of
the condensation water flowing
back to the tray when the pump
is not working. This can cause
the tray to fill with water and the
cabinet to stop working.
Reconnection to water tank
If you wish to reconnect the
condensation water to the water tank,
all you need to do is connect the two
hoses together again with the nipple.
Place the drain hose
in one of the recesses
in the panel
Rear review of the
cabinet with hose
fitted to floor drain
New hose to drain
Trimmed hose from
condensation water pump
Nipple
NB!
Do not under any circumstances
bend the hose so that water flow is
obstructed.
