Aseko ASIN AQUA, User Manual

Page: 13 / 36

EN 13
Pool Chemicals
Connection
Screw the injection valves into the plug D = 50 with thread G1 / 4 “# 12134,
glued to the T-piece. Tighten by hand only. Do not use pliers or other tools.
Connect the pH INJECTION VALVE to the piping behind the fi lter and behind VE
drainage of the measured water.
Connect the CHLOR PURE INJECTION VALVE behind the INJECTION VALVE, VE
this prevents scale formation.
to connect reagents to ASIN AQUA use PE pipe 1/4 “(6.35 mm) # 12008,
which is part of the delivery.
CANISTER CONNECTION Drill 6.35 mm and 1 mm diameter holes in the
canister cap. Pass the pipe through the cap so that it reaches to the bottom
of the canister. Place the suction basket at the end of the pipe.
PUMP CONNECTION connect the suction of the pump on the left to the
canister connect the pump discharge on the right to the injection valve.
INJECTION VALVE CONNECTION Pass the pipe through the nut, thread
the pipe onto the injection valve and tighten the nut fi rmly by hand.
Ø 1 m
m
Ø 6
,3
5 m
m
1
2
3
4
5
5
4
3
WARNING
To ensure that the joints are tight, cut the PE tube at an angle of 90 °.
Use special pliers # 13325 to cut plastic tubes. The cut must be clean
and smooth. Do not use ordinary scissors or knives!
WARNING
NEVER CONNECT pH minus reagent to disinfection pump or
disinfectant to pH pump! In the case of a cross-connection, after ten doses
ASIN AQUA displays an error message. Repair the piping installation and then
you can continue to operate your ASIN AQUA.
Plug with
D = 50 with
thread 1/4“
T-joint