Aseko ASIN AQUA Home VS, User Manual

Page: 23 / 44

EN 23
Flowmeter
The flowmeter detects flow of measured water. Dosing of chemicals will take
action only if flow of measured water to probes is detected.
Wash the check flowmeter strainer on a regular basis.
Warning: Only switch off the flowmeter in case of a failure.
Delay
Delay time after dose is time for which ASIN AQUA Home does not dose
and wait for the dose response at the measuring water. At pools is average
response time 4 to 10 min, at SPA 1 to 10 min.
Delay time after start
(upon timer switching on) is time after start for which
ASIN AQUA Home does not take any action and it waits for stabilization of a
signal from probes.
Concentration pH –
If you use the original ASEKO Pool & SPA chemicals keep the preadjusted
values. In case of use other non-original chemicals adjust concentration
according to data on the label of a chemical used.
Recommendation: Use the original ASEKO Pool & SPA chemicals
Warning:
Higher concentrations of chemicals can result in shorter lifetime
of ASIN AQUA Home components and may cause injury and health damage.
VS variable pump control
In the settings, select the type of your variable speed variable pump.
ASIN Aqua Home VS allows you to use 3 speeds of your VS pump.
Speed 1 (LOW) for economical filtration outside the TIMER.
Speed 2 (MEDIUM) for filtering during set times.
Speed 3 (HIGH) during filter backwash.
BOTTOM / OVERFLOW - Besgo 3w
During set TIMER times, water flows through the OVERFLOW (relay is activa-
ted).
Outside the set TIMER times, water flows through the BOTTOM (relay deacti-
vated).
The pool cover has no effect on the BOTTOM / OVERFLOW switching. During
filter backwash, water flows through the BOTTOM DRAIN. An alarm water level
too high will switch to OVERFLOW until the alarm expires.
Pool cover position (relay closed)
If the pool cover is closed during the filtration time set by the timer, the VS
pump speed will change to 1 (LOW).