n.v Jobetrade s.a
www.artsound.be
[email protected] R1.1 ENG
12/14
5.8 Deleting programmed function from the memory
There is a possibility to delete all programmed controls (remotes and wall
mounted transmitters) from the memory. This is done as follows:
•
Remove the plug from the mains socket.
•
Set the switch on the front to ON.
•
Press the set-up button and hold this in whilst inserting the plug
back in the mains socket. Hold the button down for at least 6
seconds.
All the addresses of the controls, are now deleted and the configuration of
these functions can be repeated, as described in sections 5.5 and 5.6.
6 Using the system
Before the ART 2.4 can be used it must be correctly installed. See section
5 for this.
6.7
The LED displays
•
Green LED (integrated in on/off button): device working
•
Temp LED (red):
o
Flashing: the device is too warm. Ensure good ventilation and
if necessary, reduce the volume in the zones.
o
The red LED says lit: The device is in heat protection mode.
Turn the device off to allow it to cool down. Ensure there is
enough ventilation. The device can be used again when it has
cooled down sufficiently.
•
Zone LEDs: these light up blue when a zone is activated
6.8
Using the RF handheld transmitter.
1.
Select the zone for which you which to
change the audio settings.
2.
Select a radio preset (1-6)
3.
Search the next of the previous strong
radio signal
4.
Select the external audio source
5.
Volume up/down and zone out button