n.v Jobetrade s.a
www.artsound.be
[email protected] R1.1 ENG
10/14
•
Press on the ‘Zone 1 – button‘ on the remote
control. The appropriate LED lights up.
•
Next, press on the key with number 1.
•
The zone LEDs will start to flash temporarily.
This is to confirm that the remote control has
been read in.
•
If the installation is equipped with several
remotes: take the next remote control and
press once again on the ‘Zone 1 – button’;
next press the key with number 1. Repeat
this untill all remotes have been read in.
•
Hold down the set-up button for approx. 3
seconds, until the LED for zone 1 lights up
continuously. The remote control can now be
used to operate the system.
5.7
Configuration for use with one or more RF handheld
transmitter and RF wall-mounted transmitters
To operate the ART2.4 with the RF handheld transmitter and the RF wall-
mounted transmitter, proceed as follows:
First, ensure that all loudspeakers are connected, as well as an
active sound source on the audio-input.
STEP 1
•
Hold down the set-up button for approx. 3
seconds until all LEDs start to flash.
•
The device is now ready to read in the
address of the remote control
•
Press on the ‘Zone 1 – button‘ on the
remote control. The appropriate LED lights
up.
•
Next, press on the key with number 1. The
zone LEDs will start to flash temporarily. This
is to confirm that the remote control has
been read in.
•