n.v Jobetrade s.a
www.artsound.be
[email protected] R1.1 ENG
8/14
5.2
Connection to an external audio source
An external sound source can be connected to the ‘Audio in’ input of the
ART 1.4 via a quality cinch interconnect cable (e.g. Oehlbach). Observe the
correct colours (white/red or Left/Right).
The input amplification can be adjusted by means of a button. (Fig1–5). In
most cases this button is set to the middle setting.
TIP: use the “tape-out” or “pre-out” connection on the amplifier and
connect this to the audio input of the ART 2.4 in order to listen to the music
selected on your amplifier in 4 other zones.
5.3
Connecting the loudspeakers.
2 loudspeakers can be connected in each zone, namely, left and right.
Ensure that the polarity of the loudspeaker is correct:
Connect the red terminal onto the + of the loudspeaker.
Connect the black terminal onto the - of the loudspeaker.
The loudspeaker can be of the 4 or 8 ohm type.
5.4
Connecting the RF aerial.
The RF aerial receive commands from the wireless controls. In order to
optimise reception, it’s important to follow the guidelines below:
•
The aerial can be attached directly to the ‘RF’ connector
(Fig1-1).