ART’S-WAY MANUFACTURING COMPANY, INC.
Manual No. 725755
OPERATOR’S INSTRUCTIONS: MANURE SPREADER
23
BEATER MAINTENANCE
C
C
SECTION C-C
DRAWING NO.
18028 rC
-
B
SIZE
DRAWING NO.
SCALE
DATE
TITLE
EXCEPT AS MAY BE OTHERWISE PROVIDED BY CONTRACT. THESE DRAWINGS AND SPECIFI- CATIONS ARE THE PROPERTY OF ARTS-WAY MFG. CO., ARE ISSUED IN STRICT CONFIDENCE, AND SHALL NOT BE REPRODUCED OR COPIED, OR USED AS THE BASIS FOR THE MANUFACTURE OR SALE OF APPARATUS WITHOUT PERMISSION.
NOTE: DO NOT SCALE
MODEL
UNLESS OTHERWISE SPECIFIED
MACHINING DRAWINGS: REMOVE ALL BURRS & SHARP EDGES.
-
APPR
CHK
DRAWN
DIMENSIONS ARE IN INCHES ONE PLACE TWO PLACE THREE PLACE ANGLES ± 0.5°
(.X) (.XX) (.XXX)
±.060 ±.O30 ±.010
REVISIONS
EP#
REV.
MATERIAL
LTR
DESCRIPTION
APPR.
DATE
E.C.N.
-
B. WEGNER
-
1:10
18028 rC
Armstrong, Iowa 50514-0288
Fax: (712) 864-3154
Phone: (712) 864-3131
Art's-Way Manufacturing Co., Inc.
WEIGHT
16.02 LB
-
NEW MODEL ON SOLIDWORKS
BEW
-
SIMILAR PART(S):
12/27/22
04/09/21
WARNING:
WARNING: MAKE SURE THAT ALL PARTS HAVE STOPPED MOVING, IGNITION KEY IS OFF
MAKE SURE THAT ALL PARTS HAVE STOPPED MOVING, IGNITION KEY IS OFF
AND REMOVED
AND REMOVED BEFORE
BEFORE MAKING ANY ADJUSTMENTS, MAINTENANCE OR REPAIRS ARE
MAKING ANY ADJUSTMENTS, MAINTENANCE OR REPAIRS ARE
MADE.
MADE.
• BEFORE EVERY DAY OF USE
, all beater teeth, knives, and scoop hardware should be
inspected for damage or signs of loosening. Replace worn or damaged hardware and refer to
[PG. 24] TORQUE VALUES or equivalent hardware torque chart for loose hardware.
• REPLACE
teeth, knives, and scoops when worn or damaged, they should be replaced in
order to keep the corresponding beater shaft as balanced as possible.
• CHECK OIL LEVEL
in beater gearbox before every day of use, add when needed to proper
level in sight plug. Recommend changing oil in gearbox annually see [PG. 19] LUBRICATION.
• GREASE BEARINGS DAILY
. Inspect grease lines for damage or wear.
• REMOVE ANY ENTANGLEMENTS
from beaters to limit potential damage to beaters.
CAUTION:
CAUTION:
If any repairs need welding, ground to nearest spot of repair. Be sure no bearings or
gearboxes are in between welder and ground connection.
