downtown
13
MOBILE PANELS
Installation guide
Panel with the Downtown Connection system
Step 1 :
Remove the laminate panel on the front of the lower section,
and install the electrical modules :
- Open the cover of the lower section of the panel and unscrew
the handle inside the box.
- Lift the panel and remove it.
Handle
Step 2 :
Install the electrical outlets.
Refer to the following section for Downtown Connection system.
Place the electric outlet in this hole and plug it into
the power bar.
Screw the power bar onto this support using the
pre-drilled holes. Exit the cable through the bottom
access.
Plate for the Downtown Connection installation.
See the following section.
Step 3 :
Install the monitor.
Remove the back panel of the upper section :
- Remove the metal top cap on top of the mobile panel.
- Lift-up the panel and remove it.
- Connect the monitor. Place the cable in the cable conduit and
plug it into the power bar.
Front of mobile panel
Install the monior
Back of mobile panel
Remove the metal top cap
Metal plate
Removable laminate panel
Installation of Downtown C. in the mobile panel
The Downtown Connection
must be installed in the lower section of
the mobile panel.
Cable access module
Electrical outlet
Transformer
Electronic box
Cable separator (welded)
Power bar
Step 1 :
Ensure that all connections are completed (p.8).
Screw the electronic box onto the metal plate with cables running
toward the cable separator (4 screws to install).
Step 2 :
Place the 4 HDMI data sharing cables in the cable access module
and keep them in place using the black plastic rings included.
NOTE, place the cables as seen below for the best use of the
system : 2 cables in front and two cables in back of the cable
separator.
Step 3 :
Connect the electronic box.
- Monitor cable (output)
Place the monitor cable into the cable conduit positioned
between the two sections of the mobile panel. Plug the cable
into the monitor.
- Electric cable (orange)
Place the transformer in the bottom of the metal case and plug
it into the power bar.
Wires at front of the separator
