Arsenal FU 321M, Operating And Maintenance Manual, Page: 6 / 64

OPERATING AND MAINTENANCE MANUAL FU 321M 3
SAFETY PRECAUTIONS
Any type of incorrect use of the machine may result in serious personal injury for
the machine operator. We suggest therewore that the advice and information of-
fered should be througly digested and adhered to as closely as possible so as to
guarantee your saafety and for the operator's safety ass well as to prolong the life-
span of the machine.
GENERAL PRECAUTIONS
* Never leave the machine working without being watched by an operator.
* The operator must be trained to operate milling machines. Training should be
done by manufacturer's or supplier's expert.
* Do not operate this machine without having previously read and fully understood
the safety precautions in this chapter.
* Do not operate this machine without having previously read and fully understood
the Instructions Manual.
* Make sure a supervisor or instructor is present the first time you work this
machine.
* Never attempt to operate the milling machine while your senses are impaired by
medication, drugs, alcohol or other substances.
* Always use safety gear (safety glasses, shoes, etc.)
* Never use gloves which could become caught in the moving parts of the
machine i.e. gloves which are too big and/or are damaged. Only use gloves which
are in good condition and are the right size for the operator. Gloves should also
be used when handling tools / components because they may be sharp.
* Always keep the machine and equipment clean.
* Do not remove nor modify safety systems or their functioning.
* The handle for manual motion of the transversal and vertical feed is to be
removed from the machine before putting on the automatic feed and the rapid
traverse.
* Position yourself at a safe distance from machine so as to avoid getting caught
in the moving parts of the machine. Do not wear watches, rings, necklaces, ties,
etc. and roll up long sleeves to your elbows, long hair should be tied back.
* Provide an adequate light source. If additional lighting is needed do not hesitate
in asking for it.
* Make sure the network voltage corresponds with the voltage marked on the
machine by the manufacturer.