Arsenal FU 321M, Operating And Maintenance Manual, Page: 13 / 64

OPERATING AND MAINTENANCE MANUAL FU 321M 66
FITTING OF THE TABLE GUARDS
The purpose of this safety system is to protect the operator when the machine
is performing any kind of operation and at same time to give the opportunity of
safety observation of the working proccess.
Polymethil-methacrylate (CRYSTACRYL 4 mm) is used for transparent parts of
this device. If any transparent part (a door or a panel) become scratched or
damaged in any way it should be replaced for safety reasons. This parts should
be cleaned regularly to avoid the operator's view obstruction.
The safety guard consists of 2 front doors and 2 side panels. Before proceeding
with any kind of operation the both front doors should be closed.
The fitting of the table guards is done by M8 bolts on both sides of the working
table keyways as shown below. First close both doors and then tighten the bolts
fully.
NOTE: The machines are being delivered with mounted safety guards.
OPTIONAL: Aninterlock system can be fitted to table guards. To fit the interlock
guard switch to the electrical cabinet, connect the two cables from the interlock
switch to slots 28 and 36 on the connector block. Remember to remove the link
between slots 28 and 36 before connecting the cables from the interlock swich.
WARNING: Any of these connections should be performed by a qualified elec-
trician or service engineer.
10