ARS Automation FlexiBowl 350, Instructions For Use Manual

Page: 37 / 84

5-3
FlexiBowl
®
- models 350 - 500 - 650 - 800
CHAPTER 5 - Transport and installation
5.1.2 Handling with packaging
HandlinG THE MaCHinE BodY WiTH paCKaGinG
Operator qualification Lifting vehicle driver
PPE required
Lifting vehicle Forklift truck with capacity of at least 50 kg
CaUTion!
Only use suitable and approved lifting vehicles; compatible with the dimensions and weight of the machine.
CaUTion!
Make sure that no one is standing under or within the operating range of the lifting vehicle.
Proceed as described to handle the machine body with packaging :
step Action
1 Put the forks of the forklift truck under the wooden crate containing the machine.
2
Make sure the forks come out of the front of the load (by at least 5 cm), far enough to eliminate any risk of the
transported part from overturning.
3
Lift the forks until they touch the load.
note: if necessary, fasten the load to the forks with clamps or similar devices.
4
Slowly lift the load ten centimetres or so off the floor and check its stability, making sure that the centre of the
load is in the middle of the lifting forks.
5
Tilt the mast backwards (towards the driver’s seat) to use the tilting moment to ensure greater stability of the
load during transport.
6 Adjust the transport speed according to the floor and type of load, avoiding sudden manoeuvres.
CaUTion!
Place the forklift truck forks as
shown in the figure.