4-2
Instructions for use and warnings
CHAPTER 4 - Description of the machine
4.3 Obligations and prohibitions
4.3.1
Obligations of users
The user (contractor or employer) must:
• take into account the skills and conditions of the operators in relation to their health and safety;
• provide the personal protective equipment adequate for the individual procedures;
• provide standard lifting means and procedures;
• ensure that individual workers respect the company rules and regulations on safety and on use of the collective and
personal protective equipment available;
• instruct staff on the procedures in case of an accident;
• instruct staff on the applicable residual risks;
• instruct staff on the devices in place for operator safety;
• instruct staff on the risks of noise emissions in the workplace;
• instruct staff on the general accident prevention rules provided for by European directives and by the legislation in
the country of machine installation.
Only allow staff who have read this manual and are properly trained to work on the machine.
4.3.2
Obligations of staff in charge (operators/maintenance technicians/technicians)
Staff
must
:
• Only carry out maintenance work with the machines switched off. Not lubricate moving parts.
• When the machine is in operation, do not work near it wearing necklaces, bracelets, ties, or other clothing that could
get caught in the mechanisms.
• An operator with long hair must tie it back to prevent it from getting entangled.
• Only work on the electrical panel, on the junction boxes, on the cables and on all electrical components with the main
switch turned off.
• When starting the machine, make sure there is nobody inside the danger zones.
• During operation, pay the utmost attention that nobody can directly access the moving parts.
• Use the protective devices provided by the employer properly.
• Immediately report any safety device faults to the employer, manager or supervisor.
4.3.3
Prohibitions of staff in charge (operators/maintenance technicians/technicians)
Staff
must not
:
• use the machine improperly, i.e. for uses that are not specified in the
“Intended Use”
section;
• remove or change the safety devices or signs without authorisation;
• carry out operations or manoeuvres of their own initiative which do not fall under their responsibility or which can
compromise personal safety or that of other workers;
• wear bracelets, rings, necklaces that can dangle and be dragged by moving parts, thereby creating danger for the
operator;
• replace or change the speeds of the machine’s components without authorisation from a manager;
• change the machine cycle;
• change the electrical connections to exclude the internal safety devices;
• use the machine if it has not been installed in compliance with applicable regulations;
• use the machine as a support point even if it is not working (with a risk of falling and/or damaging the machine);
• use the machine outside of the permitted environmental conditions (see
“chapter 5”
).
Summary of Contents for FlexiBowl 350
Page 6: ...0 6 Instructions for use and warnings TABLE OF CONTENTS PAGE INTENTIONALLY LEFT BLANK...
Page 24: ...3 6 Instructions for use and warnings CHAPTER 3 Safety measures PAGE INTENTIONALLY LEFT BLANK...
Page 82: ...9 2 Instructions for use and warnings CHAPTER 9 Attachments PAGE INTENTIONALLY LEFT BLANK...
