41
●
Parts Needed For
●
Bottom Section Roll-Up-Door
Step 29
BW41
●
●
●
●
●
9286 Door Panel (Bottom) (1)
●
●
●
●
●
7808 Bottom Angle (1)
●
●
●
●
●
8198 Vinyl Weatherstrip (1)
STEP
2
STEP
1
STEP
3
1
Layout the door panels on a flat
surface, protecting the panels from
being scratched.
2
Bolt the middle stiles at the center
of the 3 door panels where indicated
with #10-32x3/8" bolts on the outside
and square nuts inside.
3
On the door panel bottom sec-
tion, attach the right bottom brack-
et to the lower right corner and the left
bottom bracket to the left side using
#10Bx1/2" truss head screws into
end stiles.
4
Loosely install bottom angle to the
bottom section using #10-32x3/8"
bolts and square nuts. Insert vinyl
weather strip between angle and
bottom section and tighten bolts.
5
Fasten 2 lift handles to bottom sec-
tion, just below the bottom of middle
stile using 1/4-20x1/2" hex head bolts
and 1/4-20 square nuts.
6
Install the #1 hinges at the upper
corners and to the middle stile of the
bottom section using #10Bx1/2" truss
head screws.
NOTE
Be sure you fasten the lower part
of hinge to the top of each stile.
The top hinge leaf is marked.
STEP
4
STEP
6
STEP
5
