* Use the pushrod connector supplied in the accessory bag to join the section of
pushrod that came with the rudder to the end of the pushrod projecting through the
transom via the black rubber pushrod seal in the center of the rudder bracket.
Note: You might still need to adjust the length of the pushrod after you install the
steering servo (we'll do that later) in order to center the rudder for proper control when
running your boat.
* Connect the water cooling tube that projects through the transom to the nipple on
the top of the rudder blade.
Step 4: Turn Fin Installation And Performance Tip
* A curved hydro turn fin is supplied in the accessory bag along with mounting bolts
and nuts.
* On the back of the starboard sponson is a preinstalled bracket. (The starboard side
is the righthand side when looking at the boat from behind it; the sponson is the
lowest part of the hull that rides on the surface of the water.) Slip both of the supplied
bolts through the bracket and through the turn fin. Start the nut onto the top bolt then
use a 7mm spanner to hold the nut and a 4mm hex wrench to screw in the bolt. Repeat
for the lower bolt. Before finally tightening the bolts, position the turn fin as shown in
the above right photo.
