* Using a small hole opener, enlarge the second hole of the servo arm to 2.5mm in
order to get the pushrod adaptor screw to fit through.
* Install both pushrod adaptors onto the servo arms.
* Install both servo arms on to the servos and tighten them with the screws that came
with the servos. The arms should be fitted at 90 degrees to the servo bodies, and so
that they will be facing up when installed into the servo box.
* Fit the CNC servo mount and servos into the servo box remember that the 15kg
metal gear servo goes at the back of the box. Connect both throttle and steering
pushrods into their adapters. Then, screw the servo mount into the box.
Note: In this application, do not use a screw that has longer than a 10mm thread on it
as a longer screw could possibly penetrate through the bottom of the hull.
* Using a small hole opener open a 2mm hole in the corner of the servo box (see the
left picture above) for the receiver antenna wire to go through.
