* Install the switch, with the waterproof cover supplied, into the provided cutout in
the servo box cover.
* Thread the receiver antenna wire through the 2mm hole in the servo box and into
the back compartment. Seal where the wire goes through the servo box with a small
amount of silicone.
* Connect the servos and receiver battery/switch wires to the correct positions in the
receiver. Neatly arrange and secure the wires with a zip tie.
Note: A 5cell inline rechargeable battery is required for this application.
* Check that the radio and servos are operating correctly.
* Fit the servo box cover in place and secure and seal it with waterproof tape.
* Thread the receiver wire through the antenna mount on the main cover.
* Screw the main cover back to the boat by using the 6 screws you removed earlier.
* Thread the receiver antenna wire through the antenna plastic tube and secure the end
