Arris DZS3000NV, User Manual

Page: 417 / 426

40 Using your ViasatHD box
7 . Press 4 and count the LED blinks . Now you have found the 4-digit code .
If, during step 4, 5, 6 or 7, the LED does not blink at all, the code digit is 0 .
8 . For future reference, write down the code in the space provided in the remote
control battery compartment .
Using the TV code table
If, after performing a code search, your remote control still does not operate your
television, you may be using the wrong code . Try repeating the search again to locate the
correct code . If this fails, you can use the TV code table available for download from the
Viasat web site .
1 . Download the TV code table from the Viasat web site (www .viasat .se/tvcode),
find the brand of your television in the TV code table and select the first 4 digit
code in the list .
2 . Make sure your television is fully on (not in standby), and then press the TV
button on your remote control and release it .
3 . Press and hold down OK and
S
, until the red LED under the TV button blinks
twice .
4 . Use the number buttons to enter the 4-digit code for your television (the TV
button will blink twice after you have entered the fourth digit) .
5 . Press
S
to see if you are able to switch off your television .
If your television does not respond, repeat steps 1 to 5 with each code listed for
your brand . If none of the codes operate your television, or if your brand is not
listed, retry the code search described on page 39 .
6 . Switch your television back on by pressing a number button (or CH +) and
check if all the functions are working correctly .
7 . For future reference, write down the code in the space provided in the remote
control battery compartment .
Resetting your remote control
To clear all the settings you have made to your remote control and apply the factory
defaults:
1 . Press and hold down OK and
S
, until the red LED under the TV button blinks
twice .
2 . Use the number buttons to enter 9 8 1 . The red LED under the TV button
blinks twice .
The factory default values are applied to your remote control .
Settings