Arris DZS3000NV, User Manual

Page: 412 / 426

35
ENGLISH
Note
If you change these settings you must then test the incoming signal, by selecting ‘Signal Test’ from the
main Settings menu (see page 28) .
LNB Setup
Default values for a standard Universal LNB are already entered on this screen; under
normal circumstances you do not need to change these . If you change your satellite
dish installation, you may need to change the values so that your box can tune to all the
satellites available .
Universal LNB
◆
Select the number of LNBs (1 or 2)
◆
Use the number buttons to enter the Low Band LO (Local Oscillator)
Frequency and High Band LO Frequency (GHz)
◆
If you have 2 LNBs, you can select which satellite is connected to DiSEqC port A
or B (Thor or Astra 4A) . The other port setting changes automatically .
SatCR LNB
◆
Select a User Band number for Input 1 (UB 1, UB 2, UB 3 or UB 4)
Press blue to apply changes, or press red to cancel and return to the previous menu .
Notes
It is important that, while you are configuring your box for a SatCR (Satellite Channel Router)
installation, any other installed boxes (on the same SatCR LNB) must be disconnected from the mains
power supply, and must be assigned to a different User Band (UB) number .
If you change these settings you must then test the incoming signal, by selecting ‘Signal Test’ from the
main Settings menu (see page 28) .
Installing free-to-air channels
To install satellite free-to-air channels, go to Settings > System Setup > Free-To-Air
channels > Satellite Free-To-Air . On this screen:
◆
Use
U
or
D
to highlight ‘Satellite scan’ and press OK .
◆
On the screen that pops up, either select a satellite and transponder from
the available list and press green (recommended), or press blue to enter the
satellite and transponder details manually . Your box starts scanning for all the
available free-to-air channels . Please note that this scan may take a few minutes
to complete .
Settings
*DiSEqC™ is a trademark of Eutelsat.