22
4.2.2 Mounting the CCD Optic Module
and the Inserter/Antiflicker
Module
• Remove protecting cap of the video tap
§
by
turning it counter-clockwise,
and store it in case the camera is used without the IVS.
• Remove the protecting cap of the CCD optic module
§
by turning it counter-clockwise.
The video lens must be properly inserted into
the lens mount until the end of the thread.
Uncomplete insertion might result in damage to
the beam splitter when attaching the unit to the
camera body.
• Insert the CCD optic module into the video tap of the
film camera with the lens first. Make sure the connector
is pointing to the left side. Push the CCD optic module
into the camera as far as it will go. Twist the module
left or right until the key of the lens gear finds its path
and insert the module further into the camera. Tighten
the screw ring a little but do not close it entirely.
• Place the inserter/antiflicker module on the film camera
and connect it to the CCD optic module. Insert the
protecting cap
protecting cap
Setup
Summary of Contents for IVS
