C
a
m
e
ra O
p
e
ra
ti
o
n
72
Note: The mirror shutter stops in the same position
it was set to before it was started. If no
image can be seen through the viewfinder,
briefly press the PHASE button to rotate
the mirror into viewing position.
Note: As part of the daily routine of camera care,
it is recommended to perform an imager
check prior to or at the end of each day of
shooting to ensure the camera’s imager has
not taken any mechanical or electrical damage.
Detailed information on checking the imager
can be found in chapter 15: Camera Care.
Note: Unless stated otherwise, operational
parameters cannot be changed while
the mirror shutter is running.
11.2. Camera Display Modes
The camera display at the front left side of the camera
➪
image
is used to display/adjust parameters connected
with the imager's exposure. Access to these parameters
is provided through different display modes.
To change between modes:
Briefly press the
•
MODE button
➪
image
.
In each mode the corresponding
•
operational parameters can be set using
the SEL and SET buttons
➪
image
.
MODE 1 is indicated in the display by a black
horizontal bar in the top right corner
➪
image
.
