S
a
fe
ty I
n
s
tr
u
c
ti
o
n
s
13
Specific Safety Instructions
2.2.
Do not remove any safety measures of the
system!
Do not operate the system in areas with
humidity above operating levels or expose it to
water or moisture!
Do not subject the system to severe shocks!
Do not place the system on an unstable trolley/
hand truck, stand, tripod, bracket or table! The
system may fall, causing serious personal injury
and damage to the system or other objects.
Operate the system using only the type of power
source indicated in the manual! Unplug the
power cable by gripping the power plug, not the
cable!
Never insert objects of any kind into any part of
the system through openings, as the objects may
touch dangerous voltage points or short out
parts! This could cause fire or electrical shock.
Unplug the system from the power outlet before
opening any part of the system or before making
any changes to the system, especially the
attaching or removing of cables!
Do not use solvents to clean!
Do not remove any screws that have been
secured with paint!
Never run the camera without a lens or a
protective cap in the lens mount receptacle!
Attention! Danger of injury!
Never place your hand in the lens mount
receptacle or the inside of the camera while it is
running!
Before removing the lens, always make sure to
stop the mirror shutter! This not only prevents
damage to the shutter in case a wrong lens is
inserted (e.g. 16 format lens). The shutter in
"finder-open" position acts also as a protective
cover to the sensor.
Changing camera lenses should be done in a dry
and dust-free environment. If this is not possible,
take extra care that no dust enters the camera
while the lens is off!
When no lens is attached to the camera, use the
protective cap to avoid sensor contamination!
After changing lenses, always perform a dust
check to make sure no dust has settled on the
sensor cover glass!
