Camera Body
30
Attaching the Magazine onto the
Camera
Do not use HS magazines on a standard
camera or standard magazines on a HS
camera.
If appropriate press the button
on the video
carrying handle and swing the handle to the left side
of the camera.
• If appropriate swing back the on-board battery.
• Remove the loop protector and the aperture cover plate.
• Center the film loop in reference to the pressure plate,
and make sure the film is held in place by the four
guide pins.
• Flip the safety latch to the back
.
• Grasp the upper part of the magazine and hold it on
approx. 30
°
slant (two o'clock) position.
• Push the pilot pin
on the magazine forwards
into the camera housing.
• Carefully press the back part of the magazine down-
wards until it locks in place.
The red markings on the casing should
no longer be visible!
• Flip safety lever
to the front.
•
• Check that magazine is locked securely by lifting the
back part of the magazine.
• If appropriate swing back the on-board battery and
the video carrying handle.
• Set the film sensitivity on the camera´s exposure meter
and reset the film counter.
• Check the TC sensitivity setting on the magazine.
Summary of Contents for ARRIFLEX 16SR3
