Adjustment Normal 16/Super 16
52
Adjusting the Viewfinder Alignment
• Loosen the threaded bushing
with special
wrench A 16 SR-3 by approx. 2 full turns.
• Loosen the worm screw
SW 2 by approx. 10
full turns.
• Remove the threaded bushing
.
• Hold the knurled ring
firmly and completely
unscrew the worm screw
.
• Untwist the knurled ring
and remove the
viewfinder.
• Unscrew the 4 cylinder head screws
.
• Turn the friction flange 180
°
. The desired format (N
or S) must be legible.
• Replace the 4 cylinder head screws and screw tight.
• Clean the visible lens surfaces
carefully with a
moist optic cloth. If dirt clings, moisten the optic cloth
with pure alcohol.
• Remount the viewfinder in the reversed order. Adjust
the friction. See chapter 6.
When replacing the viewfinder never forget
the friction plate as otherwise the function of
the optic will be impaired.
helical retaining ring
swingover friction
adjustment
hex screws
Summary of Contents for ARRIFLEX 16SR3
