27
ARMASIGHT by FLIR
COMMAND
U S E R M A N U A L
6. Using the buttons on the control panel (Figure 3-16), configure the Command to adapt it to your
situation.
For more information on operational setting procedures, see Part 3.2 (Controls and Display Indications).
A. Adjust the brightness of the display for your comfort.
Push buttons (1) and (2) to increase/ decrease the display brightness by one level at a time until
you reach your desired brightness level.
B. Use FFC (Flat Field Correction) to improve image quality.
Push buttons (1) and (2) simultaneously to start manual Flat Field Correction.
If necessary, interrupt the automatic process by pushing the central button (3) on the control panel
during the 5-second countdown, which will appear at the bottom of the display.
C. Use the digital zoom to magnify the central area of the image.
Hold down button (1) to slowly zoom in on the image. The 2x, 4x, and 8x symbols (maximum zoom
factor is dependent on equipment model) will appear on the display.
NOTE:
Digital zoom allows distant objects to appear larger; however, the resolution will be compromised.
D. Use the image palettes for optimal visualization of temperature changes in the scene.
Hold down the palette control button (2) to scroll through available palettes. The palette name will
appear in the top part of the display.
E. Adjust the necessary adjustment using the MAIN MENU. See Part 3.2.2 (Using the MAIN MENU).
NOTE:
After configuration is complete, select EXIT on the MAIN MENU and push the SELECTION button to
leave the MAIN MENU. All settings will be saved.
10. To operate the Command in short-time activation mode, turn the switch to STB (standby). To
activate the Command, press the remote control button once. Press the remote control button again
to deactivate the Command.
CAUTION:
DO NOT leave the equipment activated when not in use.
