26
ARMASIGHT by FLIR
COMMAND
U S E R M A N U A L
3.3 OPERATING PROCEDURES
3.3.1 OPERATING
CAUTION:
DO NOT force the equipment controls past their stopping points.
CAUTION:
To prevent thermal damage to the equipment, never point it, either powered or not, directly at the
sun or any other source of high intensity light that the unprotected human eye cannot tolerate (such
as a welding arc). To prevent inadvertent exposure to these sources, never leave the equipment
without the objective lens cap secured.
Operating procedures are as follows:
1. Remove the Command from the carrying case.
2. Remove the objective lens cap.
3. Point the equipment at an object.
4. Activate the Command by turning the turn-pull switch ON. After approximately 3 sec, video of the
thermal scene should appear.
5. Adjust the Command for your eyesight by turning the eyepiece focus rings CW up to the stop, and
then CCW until the display and symbols are as clear as possible. Bring the object into focus by
turning the objective focus ring (CW for far focus, CCW for near focus).
NOTE:
The total diopter adjustment range is covered with 2 turns of the eyepiece focus ring.
The total focus range is covered with three quarter turns of the objective focus ring.
BRIGHTNESS INCREASE /
ZOOM (1)
BRIGHTNESS DECREASE /
IMAGE PALETTE (2)
MENU / SELECTION /
FFC PROCESS INTERRUPTION (3)
FIGURE 3-16. SETTING BUTTONS
