Arkon MAGS1, User Manual

Page: 19 / 27

MAGS1 User Guide 18 V1.5 22-1-2016
Flow Qn - expected flow Qn.
Electrode Cleaning
– write one for electrode cleaning.
Delete Aux + Volume
–
write value different to zero for erasing the auxiliary totalizer.
Modbus Slave Address
– Modbus device address.
Modbus Baudrate
–
setup communication speed.
Modbus Parity
– setup communication parameters.
Start Delay - time delay after device power up, measurements are not considered into tolalizers.
4.15. Service Settings
To enter this section, it is necessary to enter the Service Password.
Modbus
register Modbus
address No. of
bytes Data
type No. of
decimal Min
Value Max Value Description Read/
Write
3000 2999 4 Bool 0 0 1 Delete OK (min) R/W
3002 3001 4 Bool 0 0 1 Delete Error (min) R/W
3004 3003 4 Bool 0 0 1
Delete Total
Volume
R/W
3006 3005 4 Bool 0 0 1
Delete Negative
Volume
R/W
3008 3007 4 Bool 0 0 1
Delete Positive
Volume
R/W
3010 3009 4 Bool 0 0 1
Flow Simulation,
0=ON,
1=OFF
R/W
3012 3011 4 Longint 3 0 36 000 000 Simulated Flow R/W
Delete OK (min)
–
write value different to zero to erase the OK min counter.
Delete Error (min)
–
write value different to zero to erase the Error min counter.
Delete Total Volume
–
write value different to zero to erase the Total flow totalizer.
Delete Negative Volume
–
write value different to zero to erase the Total
– flow totalizer.
Delete Positive Volume
–
write value different to zero to erase the Total + flow totalizer.
Flow Simulation
– switch off/on the simulation flow function.
Simulated Flow
– write simulated flow.