001-1
1900-EN rev
. 5
Assembling the Semi-Permanent Rack
10
Inserting the Lift into the Track
NOTE
: Before proceeding to this step, make sure
that the second post is assembled and ready to
receive the track.
1) Insert the lift or portable trolley into the track.
2) Raise the track slightly to assure that the lift will
not roll back out of the track.
Fig. 13
3) Insert the second stopper inside the track, but
do not tighten it.
Fig. 14
Assembling the Track onto Second Post
1) Insert the track onto the second post assembly
following the same instructions as for the first
post (see previous page).
2) Fasten the assembly by tightening the two bolts
located inside the track bracket. Use the two
M12 X 30 socket low head zinc screws with
appropriate lock washers.
Fig. 15
3) Secure the end stopper in place.
Fig. 16
4) Install a plastic cap at the of the track.
Final Adjustments
1) Reposition the end stoppers in order to prevent
the lift from hitting the posts, or to reduce the
transfer area according to your needs. (eg. if
you do not want the lift to access the left portion
of the track, secure the right stopper in the
middle of the track.
2) Stabilize the
Semi-Permanent Rack
by adjusting
the two legs supports. To do so, unscrew the leg
supports in order to put them in contact with the
floor.
3)
WARNING
: The load must always be applied on
the large centre puck located under each leg.
The non-slip leg supports are only designed to
stabilize and balance the rack. They must not
support any direct load (see "Fig. 17").
Fig. 17
Floor level
Floor level
Weight is on
center puck
Weight is not on
center puck
