Arjo EASYTRACK 9330010, Instructions For Use Manual

Page: 13 / 24

001.10610.EN rev
. 13
Assembling the EASYTRACK 9
b) Press in metal pins
on both sides of the
post. Metal pins
cannot be pressed
in when there is
downward pressure
on them. Pressure
must be released to
press in pin.
Fig. 15
c) Pull up the top portion of the post
towards the ceiling.
d) Repeat until the top of the post is less
than 76 mm / 3” from the ceiling.
9) Lift the blue locking
handle out of the lower
portion of the post (see
Fig. 2 - item № 4). Using
the blue piece as a
handle, twist the post as
shown in Fig. 16:
a) Top portion – turn
counter-clockwise.
b) Bottom portion –
hold firmly.
Fig. 16
10) Before the EASYTRACK
post tightens against the
ceiling; check the clip-on
level to make sure the
bubble is in the centre of
the circle. Tilt the post
until the bubble reaches
the centre of the circle,
see Fig. 17 and Fig. 18.
Fig. 17
NOTE:
Make sure clip-on
level is fully attached to
the post. Failure to attach
level properly could give
an incorrect reading. Level
should “Click” into place.
Fig. 18
11) Once the bubble is in the centre of the clip-
on level – continue to tighten only until the
red mark at the top of the post is no
longer visible .
Fig. 19
Incorrect Correct
Red mark
visible
Red mark
not visible
WARNING : Red mark
must not be visible for
the post to be safely
secured (see the warning
label, apposed on each
post, as shown in
Fig. 20.
NOTE: Do not over-
tighten the post.
Tighten only until red
mark disappears.
Over-tightening post
may cause damage to
the ceiling.
Fig. 20
12) Remove the level from
the post by sliding it up
off the bottom portion of
the post. Slide the blue
locking device down to fit
into the bottom part of
the post to lock the post
in place.
Fig. 21
NOTE: Once the blue locking handle is
pressed into the lower portion of the post,
the post can be turned as a whole, except
for the top plate and foot plate. This will not
lower the post. The post must turn to enable
you to attach the track.
13) Repeat procedure from steps (1) for the
second and third posts.
NOTE: Make sure that all posts are far
enough from each other to allow the track to
latch on (minimum distance between each
post: 1.9 m (75”).
14) Get the Fixed track with
the swivel trolley (Fig. 2
– item № 11 & 12) and
place the end of the track
marked “Step 1” onto
one standard post, not
the post designated to
be the ‘pivot’ post. Place
the track onto the pins
and rotate the post to
desired direction.
Fig. 22
NOTE:
Tilt the track upward (45°) to latch
the track onto the post.