1.
Take the leg frame with the handlebar (Part A), and lay it flat on the ground.
2.
Determine which direction you want the seat to face in your bathtub. The leg
frame with the handlebar (Part A) will be the side that goes inside the bathtub.
3.
There are two sliding rails (Part C): one rail has 4 brass push
buttons (front rail), and the other rail has 2 brass push
buttons (rear rail).
4.
If you prefer to sit facing left (if looking at the tub from
outside), take the rail with 4 push buttons (front rail), and
insert it into tube X (or insert it into tube Y if you want to sit
facing right). Make sure the two smaller push buttons face
forwards (the smaller push buttons are for the sliding rail
locking mechanisms). Make sure the larger button snaps
firmly into the leg frame.
5.
Insert the rear sliding rail into the other side of the leg frame
(Part A), making sure the button snaps firmly into place.
6.
Take the seat with the attached
sliding rings (Part D), and align
the sliding rings with the rails,
so that the locking
side of the seat
(the side with the red
tabs) is on the same
rail as the 4 brass
push buttons. Insert
both sliding rails into
the sliding rings
under the seat. Push
in the push buttons
to slide the seat
easily onto the rails.
7.
Take the other leg frame (Part B),
and insert the sliding rails into it.
Make sure the brass
buttons snap firmly
into place.
8.
Take the 4 legs (Part E), and insert
them into the leg frames. Set
the bench height by using the same
button-hole location for each leg.
Make sure the buttons snap firmly
into place. For your safety, adjust
the rubber tips on the legs by
turning
them
outward
for
maximum
floor
contact.
9.
Sit the bench up on the legs. Take
the backrest (Part F), and press
the two brass push buttons on
the frame of the backrest.
Insert the
backrest into the tubes underneath
the seat,
and push it
in until
the brass
push
buttons
snap firmly
into place.
Y
X
