Arjo EASYTRACK 9330010, Instructions For Use Manual

Page: 16 / 24

001.10610.EN rev
. 13
Disassembling the EASYTRACK 12
Requirements:
• 4-step ladder
• Someone to assist you
Disassembling Procedure
1) Remove the lift from the assembly before
adjusting or disassembling the
EASYTRACK
System.
2) Remove plastic strips
from the sides of the
posts. To remove, take
one end of the strip and
gently pull outward.
Fig. 37
3) Remove the cap from
both ends of the fixed
track, by pulling them
away from the post.
Fig. 38
4) Using a step ladder,
reach under the section
at the end of the pivoting
track and remove the
cap off of the end of the
track.
Fig. 39
5) Locate the end stopper
from inside the top of the
track.
6) Using the Allen key
provided, loosen the
stopper and slide it out of
the track.
Fig. 40
7) Shorten the fixed track to
slide it out of the trolley.
Do not squeeze sides of
track together when
attempting to extend or
shorten the track.
Squeezing the track
makes it more difficult to
slide.
Fig. 41
8) Once the track is
disengaged from the
trolley, tilt it to a 45° angle
and lift the end at the
pivoting post to release it
from the hooks.
Fig. 42
9) Put the end stopper back
on the track and secure
it by tightening the Allen
key.
10) Put the blue caps back
at both ends of the track.
Fig. 43
11) Place all pieces into a box or bag to protect
them from dust and/or damage.
12) Using a step ladder,
reach under the section
of the fixed track labelled
“Step 2”. Slightly pull the
blue tab away from the
post to release the lock
on the track.
Fig. 44
13) Push end of track to
shorten the track and tilt
the track downward
(45°). The other end of
the track should easily
be released from the
post.
Do not squeeze sides of
track together when
attempting to extend or
contract the track.
Squeezing the track
makes it more difficult to
slide.
Fig. 45
14) Place the track in a box or a bag to protect
it from dust and / or other damage.
15) To remove the post, slide up the blue handle
out of the bottom part of the post to unlock
it.
16) Loosen the post by
rotating the handle as
shown in Fig. 46:
a) Top part of post –
turn clockwise.
b) Bottom part of post –
hold firmly.
Fig. 46
Disassembling the EASYTRACK