Arjo AtmosAir 9000A, Instructions For Use Manual

Page: 10 / 316

6
AtmosAir Pump Installation
Pump installation
1. Place pump on a solid stationary surface or suspend on end of bed frame with
built-in hanger.
2. Attach pump hoses to mattress, as shown with (Figure 1) below:
• Attach hoses to the mattress connectors on the
patient left side of
the mattress for alternating p ressure .
• Ensure pump hoses are attached to pump.
3. Ensure air hoses are not kinked and will not be pinched by any articulated bed
mechanisms.
4. Attach hose connector to the pump.
5. Plug pump unit into a properly-grounded wall outlet.
6. Verify power to this outlet is not controlled by a wall switch.
7. Switch pump on.
Figure 1 Mattress Hose Connector
LED Indicators
1. Green LED is lit when the pressure is at the set level.
2. Yellow LED is lit when the pressure is below the set level. Check connections.
Pump Hoses
Mattress
Connectors
Tag
AtmosAir
MIN.
POWER
LOW PRESSURE
NORMAL PRESSURE
OFF
ON
MAX.
ALT. PRESSURE / ROTATION
Figure 2 Control Panel