1X-E4 Series Operation Manual
3
Configuration options
Configuration options may result in changes to interface buttons and LEDs. See
Table 3 below.
Table 3: Configured changes to interface buttons and LEDs
Item
NEN 2575
NEN 2575 with EN 54-13
9
Service Detector
Fault Output Fault/Disabled
Operator controls and indicators
The following table gives an overview of the control panel operator controls and
indicators. Item numbers refer to Figure 1 on page 2.
Operational features described here may not be available to all users. Further
information on control panel operation and access restrictions can be found in
the topic “Control panel operation” on page 11.
Table 4: Operator controls and LED indicators
Item
Control/LED
LED colour Description
1
Zone buttons and
LEDs
Red/Yellow Disables or tests a zone (when pressed with the
General Disable or General Test button).
A red LED indicates an alarm in the
corresponding zone.
A flashing red LED indicates that the fire alarm
was activated by a detector. A steady red LED
indicates that the fire alarm was activated by a
manual call point.
A yellow LED indicates a fault, test, or
disablement in the corresponding zone.
A flashing yellow LED indicates a fault. A steady
yellow LED indicates that the zone is disabled or
is being tested.
2
Evacuation Area
buttons and LEDs
Red/Yellow Disables or tests the evacuation area (when
pressed together with the General Disable or
General Test button).
The red LED indicates an evacuation alarm in the
corresponding evacuation area.
A flashing yellow LED indicates a fault. A steady
yellow LED indicates that the evacuation area is
disabled or is being tested.
3
Supply LED
Green
Indicates that the system is powered up correctly.
4
General Fault LED Yellow
Indicates a fault. The corresponding zone, device,
or function fault LED also flashes.
