Aria-24
ipe
Digital Key Telephone System
Installation Manual
Issue 1.5
Aria Technologies
79
7.2.3 How to enter the programming mode
1.
Lift handset or press the
[MON]
button on the ADMIN station, and hear ICM dial tone
(optional).
2.
Press the
[TRANS/PGM]
button and dial
＊
#
(Confirmation tone is heard).
※
Enter ADMIN password if the password has been set. This places the station into the
ADMIN programming mode (Confirmation tone is heard).
3.
Each program is accessed by pressing the
[TRANS/PGM]
button and dialing the three-digit
program number. If an error is made while entering data, the
[TRANS/PGM]
button can go
the previous status. When the
[TRANS/PGM]
button is pressed, the LCD will display;
* NOTE :
1.
To return the parent state while ADMIN programming, press the [CONF]
button. Pressing the [CONF] button, temporary data fields are cleared.
7.2.4 Permanent update procedure
When the data has been entered, the
[HOLD/SAVE]
button is used to store the data permanently.
If all data was entered correctly, confirmation tone is heard when pressing the
[HOLD/SAVE]
button.
If there were any errors in the entry, then an error tone is presented and data is not stored in the
permanent memory.
7.2.5 How to reset the system
To reset the system, enter PGM 450 – FLEX 15 and press
[HOLD/SAVE]
button. Or press
Reset button on MBU/MBUB, located near the VMIB/AAFB Slot.
ENTER PGM NUMBER
