ARGSeguridad ZDAS-300, User Manual

Page: 7 / 16

If after 15 seconds the user does not press the * key to confirm the alarm, the panel will
auto dial next phone number.
After the entry of the listening in status, the next operating steps are same as the remote
control In section 4.9 previous.
4.11 Detector Battery Low Voltage Display On the Panel And Introduction
When detector has been in the low voltage state, it will not run correctly. The Panel can
receive the detector low voltage signal and display on the LCD and sound a beep to indicate
user to replace detector's battery in time.
+12
V JD Auto L7 L6
output
1 2 V i n p u t
L5 L4 L3 L2 L1 LAMP GND
Note:
GND: the negative electrode of the
power supply , siren , wired
detector and alarm output
L1.L2.L3.L4.L5.L6.L7 (wired detector):
lamp out: connect the relay for turn
on the lamp, this signal is
high-low contral
+12v: continued output for the wire
Power
Low voltage display and introductions:
A: When the panel is in the DISARMED mode, if the detector such as PIR detects itself
Phone Phone line
ON OFF
sensor or other accessaries
JD: output 12V for the wired siren or
other accessaries when alarm
being low voltage, the panel will sound a beep every seconds and display the signal
On the LCD continually.
Figure 3: The back view of the panel
Everything you need to know about your Security System is displayed on the Panel
keypad. The zones armed or disarmed and the important messages regarding system status
appear on the LCD screen.
LOG
M D H M D
2. 2 The LCD Character details and description
2.2.1 The panel LCD screen whole information shows as follows:
Figure 23: Detector No 2 in zone 3 is low voltage
LOG
DIS PART
ARMED
WatchDog
M D H M D
B: When the panel is in the Armed/PART Armed mode, if the detector such as PIR detects
itself being low voltage, the panel will sound a beep every seconds and display the signal
armed zone and detectors No on the LCD alternately.
C: Even if the panel LCD displays the detector low Voltage, the operation also can be
done normally on the panel and stop provisionally low voltage display.
SETRMOT TYPECONFIG ALM PIN TESTTIMED GSM PHONE
ON=Sounder as alarm
OFF=Silent as alarm
How to cancel the low voltage display:
A: Press 'Delete' key and - - - appears on the LCD. Press registered Key Fob or enter your
PIN, LCD will display 'DEL Sensor' u se keypad to select zone(s) 1 to 8. Use Keypad to select
Detector(s) 1 to 9. Program the 4th field with 0. Press Key Fob Exit. (Refer to figure 25)
B: Press the key Fob
N.B.: When the battery has been replaced, the user must program the 4the field with 0
ARMED
DIS ARMED
PARTARMED
Watchdog
LOG
M
D
H
M
D
Panel armed
Panel disarmed
Panel part armed
Avaible
Event log
Month
Day
Hour
Minute
Weekday
SET
RMOT
TYPE
CONFIG
ALM
PIN
TEST
TIMED
GSM
PHONE
Set program
Remot Zone
type System
config Alarm
Wireless sensor battery low voltage
Pin code
Walk test
Timed auto arm or disarm
GSM signal avaible
C.s. Phone or user owner phone
manually. And then the panel will display normally.
Figure 4: All the info. the LCD displays
23 4