Argox AS-8020, Manual

Page: 133 / 145

133
String setting / Transmission
(Insert Group Characters)
Insert G1/G2/G3/G4 character setting:
The imager
supports inserting two groups with each group 22 characters
into transmitted data of selected symbologies. The two
groups can be inserted into scanned data of the selected
symbologies or positioned at leading / ending of data. There
are total four groups for utilization.
Insert data group position: To define the position of a group
to insert into bar code data. Please notice that the inserting
position of a group must not exceed the code length; or the
insertion will be positioned at the ending of data.
Notice: Default value “ 00 ” indicates the group to be
positioned at the leading of data. “64” represents for
positioning the group at the ending of data.
Insert data group setting procedure:
i. Define the characters of groups for insertion.
ii. Setup the inserting position of each group in
scanned data.
iii. Select one or two groups to insert into specific
bar codes. Please refer to the setting pages of
each bar code.
Example: Barcode
“ 1 2 3 4 5 6 ” .
Output- Barcode “ 1 2 A B 3 4 C D 5 6 ” .
Steps:
1) Scan Programming and
Insert G1 characters setting
barcode.
2) Use the ASCII code table to find the value of A
→
41,B
→
42.
3) Scan 4, 1 and 4, 2 from the barcode on the fold out back
page.
4) Scan Finish from the barcode on the fold out page.