Original User Manual
–
A
REBO
S Convector 2300W
15
Info: The display has a backlight. The backlight turns on as soon as one of the buttons on the control
panel or the remote control is pressed. After about 1 min without actuation, the backlight turns off
again.
Turn on the device control panel
After you have set up the device ready for operation as described in the chapter Assembly and
Commissioning, you can switch it on.
•
Set the power button (8) to position I.
The device is now in standby mode.
•
Press the Power button (2).
The device is turned on.
Setting operating modes
The device has the following operating modes:
•
Heating mode
•
Frost Guard Mode
Set heating mode
•
Press the Mode button (5) until the desired heating level is selected. You can choose between
three levels.
The selected performance level (12) is displayed in the segment display.
Frost Guard Mode
In frost guard mode, the device heats automatically. This temperature cannot be changed.
•
Press the Mode button (5) until the Frost Guard indicator appears.
The device heats automatically when the temperature is below 5 °C.
Set desired room temperature control panel
The room temperature determined by the temperature sensor is displayed in the Actual
Temperature (11) display. You can set the desired room temperature at any time. The setting is only
possible in heating mode. The room temperature is preset to 25 °C.
•
Press the Increase Value (7) or Decrease Value (8) arrow key to set the desired room
temperature. The setting range is between 5 °C and 37 °C in 1° steps.
The set room temperature is displayed in the Target Temperature (14) display.
Info: The desired room temperature should be higher than the current room temperature.
Ventilation control panel
•
Press the Ventilation button (6) to turn on the fan.
The Ventilation (13) indicator appears.
•
Press the Ventilation button (6) to turn off the fan.
The Ventilation (13) indicator goes out.
Set timer
The timer works as follows:
•
automatic switch-off according to the preset number of hours.
The number of hours can range from 1 to 24 hours and can be set in 1-hour increments. If the timer is
enabled, the time is also displayed in minutes.
Hint!
The device must not be operated unattended in a freely accessible room when the timer is
active.
