Original User Manual
–
A
REBO
S Convector 2300W
12
•
After the installation is complete, place the device on a fixed, flat surface and make it
operational.
Commissioning
Info: Odor formation can occur during the first commissioning or after a long period of non-use.
When setting up the device, observe the minimum distances to walls and objects according to the
chapter Technical data.
Before recommissioning the device, check the condition of the power cord. If you have any doubts
about its perfect condition, call customer service.
•
Place the device upright and stable.
•
Avoid tripping points when laying the power cable or other electrical cables, especially when
placing the device in the middle of the room. Use cable bridges.
•
Ensure that cable extensions are fully rolled out or unrolled.
•
Make sure that curtains or other objects do not hinder the flow of air.
•
Do not place the device directly under a wall outlet.
•
Make sure that the device cannot come into contact with moisture or water.
Insert batteries into remote control
Warning!
before electric voltage Do not touch the battery
compartment with damp or wet hands.
Do not run the device with rechargeable batteries!
Please note the technical data during commissioning.
•
Open the battery compartment on the back of the remote control and insert a button battery.
To do this, squeeze the latch on the side of the battery compartment and pull the battery
compartment out of the remote control.
•
Insert a CR 2023 battery into the battery compartment and slide the battery compartment
back into the remote control. To do this, place the battery in the slot, where the anode and
cathode must point in the right direction.
•
Attach the rear cover. Slide the cover to open. Pay attention to the right direction.
Please note:
•
The anode and cathode of the batteries must match the "+" and "-" characters on the remote
control.
