p22
5.2.3 Visualisation and setting of the alarm setpoints
5.2.4 Setting of the tare
(except temperature inputs)
Press and to enforce the signal currently present on the input
as display down scale
Note
: The tare will not be recorded in case of power supply cut.
To suppress the tare, validate the menu in the main menu
p20
.
An exit from the mode programming with saving of the configuration will
reset the tare to 0.
M
Setting of the setpoints:
There are 2 ways to adjust setpoints:
- either in mode programming entering the correct safety access code
(see p18)
- or by pressing simultanesously and
d.disP
CLr.tA
The meter will then show the message SP.x or SPx.x alternating with
the value of the corresponding setpoint.
The various values of the setpoints can be accessed by and .
These setpoints can then be modified (if access code < 6000
(see p18)
)
by pressing
When the setpoint is adjusted press to revert to the setpoints
reading menu.
Once all the setpoints have been adjusted, simply press
and the
meter will revert to the mode measure, taking the new values into
account.
If no key is pressed after 60 s. the meter will revert to the measure dis-
play without modification of the setpoints value.
(accessible according to the programmed access code)
M
7. GENERAL WARRANTY TERMS
WARRANTY applying and duration
This appliance is garanteed for a duration of 1 year against any design
or manufacturing defects, under normal operating conditions.
Processing conditions * :
Processing not under warranty will be sub-
mited to the acceptance of a repair estimate. The customer will return
the products at his charge, and they will be restored to him after
processing. Without a written agreement on the repair estimate within 30
days, the products will not be held.
* Complete warranty terms and details available on request.
8. LEXIQUE
Messages shown by the meter in mode programming and/or in
mode reading
General access
Access to the reading of the parameters
Access to the programming of the input and output parameters
Code for access to the programming of the input and
output parameters
Programming of a new access code
Access to the display simulation
Access to the simulation of the analog output
Deleting of the recorded alarms
Suppressing of the tare
rEAd
ProG
CLEAr
CLr.tA
CodE
SIMUL
P.CodE
GEnE
2000
OPEn
Er.01
6. ERROR MESSAGES
Measure in overrange
Sensor rupture
Value set out of range
«
----
OL
Er.xx
Upper or lower electrical
overstepping of the input
Displayable value overload
Self-diagnosis error
(see page 14)
Option 2 or 4 relays
If the function has been locked (according to the access code) the code
must be entered.
If the function has been locked (according to the access code) the code
must be entered.
E.xxx
or
