58
Preparation after Storage
Taking the snowmobile out of storage
and correctly preparing it for another sea-
son will assure many miles and hours of
trouble-free snowmobiling. Arctic Cat
recommends the following procedure:
1. Clean the snowmobile thoroughly.
Polish the exterior of the snowmobile.
2. Clean the engine. Remove the cloth
from the exhaust system. Check
exhaust system and air-intake
silencer for obstructions.
3. Inspect all control wires and cables
for signs of wear or fraying. Replace
if necessary. Use cable ties or tape to
route wires and cables away from
hot or rotating parts.
4. Inspect the drive belt for cracks and
tears. Check belt specifications.
Replace if damaged or worn. Install
the drive belt.
NOTE: If the old belt is worn but in
reasonable condition, retain it with
the snowmobile as a spare in case of
emergency.
5. Inspect all fuel hoses and oil hoses
for deterioration or cracks; replace if
necessary. Make sure all connections
are tight; then on the
800 cc models,
fill the oil-injection reservoir with the
recommended 2-cycle oil (see Gaso-
line-Oil - Recommended Injection
Oil sub-section in the General Infor-
mation section).
NOTE: After prolonged storage of
the 800 cc models, Arctic Cat recom-
mends one tankful of 100:1 gas/oil
mixture be used in conjunction with
the oil-injection system to ensure
proper lubrication.
6. On the 800 cc models, inspect the
spark plugs. Replace, gap, or clean
as necessary.
7. Tighten all nuts, bolts, and cap
screws making sure all nuts, bolts,
and cap screws are tightened
securely.
8. If not done during preparation for
storage, lubricate the rear suspen-
sion with all-temperature grease.
9. Check the coolant level and all cool-
ant hoses and connections for deteri-
oration or cracks. Add properly
mixed coolant as necessary.
10. On electric start models, charge the
battery until fully charged (see Bat-
tery sub-section in the Maintenance
section); then connect the battery
cables making sure to connect the
positive cable first. Test the electric
start system.
11. Inspect the entire brake system, all
controls, headlight, taillight, brake-
light, ski wear bars, and headlight
aim; adjust or replace as necessary.
12. Adjust the track to the proper tension
and alignment (see Track Tension
and Track Alignment sub-sections in
the Maintenance section).
Summary of Contents for M 1100 Turbo
Page 7: ...3 Snowmobile Safety Rules...
Page 64: ...60 NOTES...