Arctic Cat M 1100 Turbo, Operator'S Manual

Page: 25 / 68

21
1. Remove the hairpin clip from the pin
located at the front of the access
panel. Move the panel up and off the
pin; then swing the panel all the way
out and unhinge the panel from the
lower console.
2. Remove the two torx-head screws
securing the hood (located on the
underside of the hood above the rear
tube of the upper A-arm); then
remove the two torx-head screws
from the top-side of the hood secur-
ing the hood to the upper console.

NOTE: On the turbo models,
remove the two torx-head screws
from under the nosepiece of the
hood.
3. Locate the hood harness connector
(located in front of the speedometer)
and unplug the connector; then
move the hood slightly forward and
remove the hood.

NOTE: On the turbo models, first
unhook the rubber straps securing
the air filter housing to the intake
plenum of the hood; then move the
hood slightly forward and remove
the hood.
To install the access panel and hood, use
the following procedure:
1. Position the hood onto the snowmo-
bile and connect the hood harness
connector.

NOTE: On the turbo models prior
to securing the hood, make sure the
rubber straps of the air filter housing
are accessible.
2. Secure the hood with the six torx-
head screws and tighten securely.

NOTE: Before installing the hood,
make sure the mounting screw clips
are in position.

NOTE: On the 1100 cc non-turbo
models, make sure the foam seal is
in place on the air intake.

NOTE: On the turbo models, make
sure the air filter housing is properly
connected and secured with the rub-
ber straps to the intake plenum of
the hood and turbocharger.
3. Install the access panel onto the
lower console; then close the access
panel and scure with the hairpin clip.
Removable Seat
These snowmobiles are equipped with a
removable seat. To remove the seat, use
the following procedure:
Remove the torx-head screw from the
underside of the seat; then lift on the back
of the seat and move it up and rearward
to remove it from the tunnel.
746-088A
To install the seat, use the following pro-
cedure:
Slide the front of the seat into the locking
position of the seat support bracket; then
lower the rear of the seat into position on
the tunnel. Secure with the torx-head
screw.

NOTE: On the 1100 cc LXR models
prior to lowering and securing the
seat, connect the seat heater har-
ness connector.
Towing
If the snowmobile is to be towed by
another snowmobile, do not tow using
the loops in the skis. The tow rope should
be attached to the spindles.
CAUTION
On the 1100 cc LXR models prior to
removing the seat, lift the rear of the
seat and disconnect the seat heater
harness connector.