2
General Information
NOTE: Some photographs and illustrations used in
this manual are used for clarity purposes only and
are not designed to depict actual conditions.
NOTE: Whenever a part is worn excessively, cracked,
or damaged in any way, replacement is necessary.
Specifications
Specifications subject to change without notice.
CHASSIS
Length (Overall)
146.8 cm (57.8 in.)
Height (Overall)
96.2 cm (37.9 in.)
Width (Overall)
87.6 cm (34.5 in.)
Tire Size
(Front)
(Rear)
AT20 x 7-8
AT19 x 8-8
Tire Inflation Pressure
0.21 kg-cm
2
(3.0 psi)
MISCELLANY
Spark Plug Type
CR7HSA
Spark Plug Gap
0.6-0.7 mm
(0.024-0.028 in.)
Dry Weight (Approx)
118 kg (260 lb) - DVX
120.2 kg (265 lb) - Utility
Gas Tank Capacity
5.7 L (1.5 U.S. gal.)
Reserve Capacity
1.3 L (0.34 U.S. gal.)
Transmission Lubricant
(Recommended)
SAE 80W-90 Hypoid
Transmission Lubricant Capacity
250 ml (8.4 fl oz)
Engine Oil Capacity
0.8 L (0.84 U.S. qt)
Gasoline (Recommended)
87 Octane Regular Unleaded
Engine Oil (Recommended)
Arctic Cat ACX All Weather
(Synthetic)
Headlight
12V/35W
Brakelight
12V/5W
FUEL SYSTEM
Carburetor Type
Keihin PTE
Main Jet
80
Slow Jet
40
Pilot Screw Setting (turns)
1 3/8
Needle Jet
3.4/2.5
Jet Needle
NGRA-3
Idle RPM
1700
Needle Valve/Seat
1.6
Float Arm Height
10.2 mm (0.40 in.)
Throttle Cable Free-Play (at lever) 6.0 mm (0.25 in.)
ELECTRICAL SYSTEM
Ignition Timing
28° BTDC (“F” Mark) @ 4000 RPM
Ignition Type
CDI
Spark Plug Cap
4725-5775 ohms
Ignition Coil
(primary)
Resistance
(secondary)
Less than 1 ohm
2830-3170 ohms
Timing Sensor
(peak voltage)
(resistance)
1.8-3.8 DC volts
80-160 ohms
Regulator/Rectifier
12.1-15.2 DC volts@ 3000 RPM
CDI/Ignition Coil
(peak voltage) 190-282 DC volts
Stator Coil (no load)
13.5-16.5 AC volts @3000 RPM
Stator Coil Resistance
Less than 1 ohm
Choke Circuit(voltage)
3.5-4.5 AC volts
ENGINE
Piston Ring End
(top)
Gap (Installed)
(2nd)
(oil)
0.15-0.30 mm
0.30-0.45 mm
0.20-0.70 mm
Piston Pin Outside Diameter (Min)
12.96 mm
Piston Pin Bore (Max)
13.03 mm
Piston Skirt/Cylinder Clearance (Max)
0.10 mm
Cylinder Head Distortion (Max)
0.05 mm
Cylinder Bore Trueness
50.00-50.05 mm
Connecting Rod (Small End Inside
Diameter) (Max)
13.06 mm
Connecting Rod (Small End Deflection)
(Max)
0.40 mm
Connecting Rod/Crankshaft Clearance
(Side to Side) (Max)
0.05 mm
Crankshaft (Runout) (Max)
0.10 mm
Camshaft Lobe Height (Intake) (Min)
26.33 mm
Camshaft Lobe Height (Exhaust) (Min)
25.65 mm
Rocker Arm to Shaft Clearance (Max)
0.10 mm
Intake Valve Stem to Guide Clearance
(Max)
0.06 mm
Exhaust Valve Stem to Guide Clearance
(Max)
0.08 mm
Valve Stem Runout
0.02 mm
Valve Face/Seat Width
0.63 mm
Valve Face Radial Runout
0.025 mm
Crankshaft Web-to-Web Distance
45.15-45.20 mm
Oil Pump Outer Rotor to Body Clearance
(Max)
0.25 mm
Oil Pump Outer to Inner Rotor Clearance
(Max)
0.20 mm
Oil Pump Rotor End Clearance (Max)
0.12 mm
V-Belt Width (Min)
16.5 mm
Centrifugal Clutch Housing (Max)
107.5 mm
Centrifugal Clutch Lining Thickness (Min) 1.0 mm
Driven Pulley Spring Free Length (Min)
154.6 mm
Roller Guide Diameter (Min)
15.4 mm
Movable Drive Face Collar (Max)
24.06 mm
