63
GENER
A
L MAINTENAN
CE
KM147A
CD628
5. Install the O-ring, screen/filter,
compression spring, and the O-
ring; then secure with the screen/
filter cap. Tighten cap to 11 ft-lb.
6. Remove the oil fill plug; then pour
recommended oil into the crank-
case. Install fill plug.
7. Start the engine (while the ATV is
outside on level ground) and allow
it to idle for a few minutes.
8. Turn the engine off. Check the oil
level in the oil level inspection
window. The oil level should be
between the low and high marks.
9. Inspect the area around the screen/
filter cap for leaks.
Transmission
Lubricant
Change the transmission lubricant at
the scheduled intervals. The transmis-
sion should always be warm when the
lubricant is changed so it will drain
easily and completely.
1. Park the ATV on level ground.
2. Remove the fill plug. Be careful
not to allow contaminates to enter
the opening.
KM104A
3. Remove the drain plug and drain
the lubricant into a drain pan.
KM106A
4. Install the drain plug and tighten to
22 ft-lb.
5. Pour correct amount of recom-
mended lubricant (see specifica-
tions chart) into the fill plug hole;
then install the fill plug and tighten
securely.
6. Start the engine and drive the ATV
to warm up the transmission; then
check for any leaks around the
drain and fill plugs.
Rear Drive Lubricant
(Utility)
Change the rear drive lubricant at the
scheduled intervals. The rear drive
should always be warm when the lubri-
cant is changed so it will drain easily
and completely.
