54
NOTE: High engine RPM, low
vehicle speed, or heavy load can
raise engine temperature. Decreas-
ing engine RPM, reducing load,
and selecting an appropriate trans-
mission gear can lower the temper-
ature.
NOTE: Debris in front of the
engine (or packed between the
cooling fins of the radiator) can
reduce cooling capability. Using a
garden hose, wash the radiator
and the engine to remove any
debris restricting air flow.
4.
Speedometer
(4)
- Displays
approximate vehicle speed in mph
or km/h.
NOTE: To shift the display
between mph and km/h, press the
Mode/Set Button for two seconds.
The LCD will display either mph or
km/h on the right-side of the dis-
play. The Odometer/Trip Meter (7)
will shift to correspond (miles/kilo-
meters) with the speedometer.
5.
Fuel Level Indicator (5)
- Indi-
cates approximate amount of gaso-
line in the gas tank.
NOTE: When the bottom seg-
ment flashes, gasoline quantity is
low.
6.
Digital Clock (6)
- Displays time
in hours and minutes when the
ignition switch is turned to the ON
position. To set the time, turn the
ignition switch to the ON position;
then use the following procedure.
NOTE: If the Hour Set or Minute
Set operation is interrupted for
more than 10 seconds, the clock
will return to normal operation.
A. Hour Set: Press and hold
Mode/Set Buttons (1) and (2)
until the hour display flashes;
then release both buttons and
again press Mode/Set Button
(2) to select the desired hour.
When the desired hour is dis-
played, release the button.
NOTE: The clock displays a
sequential 24-hour time only.
There is no 12-hour AM/PM desig-
nation.
B. Minute Set: Press and hold
Mode/Set Button (1) until the
minute display flashes; then
release the button and press
Mode/Set Button (2) to select
the desired minute. When the
desired minute is displayed,
release the button.
NOTE: When the button is
released for more than 10 sec-
onds, the clock will return to nor-
mal operation.
7.
Odometer/Trip Meter (7)
- Dis-
plays distance in miles or kilome-
ters the vehicle has traveled. The
odometer (ODO) displays total
distance and cannot be reset to
zero. The trip meter (TRIP) dis-
plays distance and can be reset to
zero. The distance (miles/kilome-
ters) will correspond to the speed-
ometer. To shift between (ODO)
and (TRIP), press and hold Mode/
Set Button (2) for two seconds. To
reset the (TRIP) display to zero,
shift the display to (TRIP); then
press and hold Mode/Set Button
(2) and simultaneously press
Mode/Set Button (1) until the dis-
play reads zero. Release the but-
tons.
CAUTION
Arctic Cat does not recommend
using a pressure washer to clean
the radiator core. The pressure may
bend or flatten the fins causing
restricted air flow, and electrical
components on the radiator could
be damaged. Use only a garden
hose with spray nozzle at normal
tap pressure.
