50
Brake Lever Lock
To engage and release the brake lever
lock, use the following procedure.
KM161B
1. Squeeze the hand brake two or
three times and release it.
2. Push and hold the brake lever lock.
3. While pushing forward on the
brake lever lock, squeeze the brake
lever.
NOTE: It will click as it engages
and the brake lever will not return
to its released position.
4. Release the brake lever lock by
squeezing the brake lever. It will
return to its released position.
Check to make sure the brake lever
lock engages properly and that the
brake (when engaged) locks the
wheels.
1. Pump the brake lever 2 or 3 times.
2. Engage the brake lever lock.
3. Attempt to push the ATV.
NOTE: The brake lever lock must
lock the wheels. If it doesn’t, take
the ATV to an authorized Arctic Cat
ATV dealer for service.
Headlight OFF/HI/LO
Switch
Use the headlight OFF/HI/LO switch
to select the high or low headlight
beam when the ignition switch is in the
LIGHTS position. When the switch is
in the HI position, the high beam will
illuminate. When the switch is in the
LO position, the low beam will illumi-
nate. When the switch is in the OFF
position, only the taillight will illumi-
nate.
KM161C
Emergency Stop
Switch
OFF position
- The ignition circuit is
off. The engine cannot be started or
will not run. If the emergency stop
switch is used to stop engine without
turning off ignition switch, the battery
may discharge.
! WARNING
Always check to be sure that the
brake lever lock has been disen-
gaged before operating the ATV. An
accident could result if the brake
lever lock is left engaged while the
ATV is operated. The brake may
relax if left engaged for a long
period of time. This could cause an
accident; therefore, do not leave the
ATV on a hill depending on the
brake lever lock. Always block the
downhill side of the wheels if leav-
ing the ATV on a hill or park the ATV
in a sidehill position.
