85
1. Remove a front wheel.
2. Measure the thickness of each
brake pad.
3. If thickness of either brake pad
is less than 2.0 mm (0.078 in.),
take the ATV to an authorized
Arctic Cat ATV dealer to have
brake pads replaced.
Brake Lever Lock
Check to make sure the brake lever lock engages properly and that the
brake (when engaged) locks the wheels.
1. Pump the brake lever 2 or 3
times.
2. Engage the brake lever lock.
3. Attempt to push the ATV.
NOTE: The brake lever lock must
lock the wheels. If it doesnít, take
the ATV to an authorized Arctic Cat
ATV dealer for service.
PROTECTIVE RUBBER BOOTS
The protective boots should be inspected periodically according to
the Maintenance Schedule.
Ball Joint Boots
(Upper and Lower/Right and Left)
1. Secure the ATV on a support
stand to elevate the front
wheels.
2. Remove both front wheels.
3. Inspect the four ball joint boots
for cracks, tears, or perforations.
4. Check the ball joint for free-
play by grasping the steering
knuckle and turning it from side
to side and up and down.
5. If boot damage is present or ball joint free-play seems excessive,
contact an authorized Arctic Cat ATV dealer for service.
730-434D
KM161B
1
KM 17A
n
250_DVX MANUAL
02.08.2006, 15:29 Uhr
88