34
11. Secure the main black negative
cable and the small black negative
cable to the battery using a cap
screw, lock washer, and a flat
washer. Tighten securely.
NOTE: Assure the harness wires and
cables are routed properly as noted
during removing battery procedure.
XM127A
12. Install the battery bracket/solenoid
and tighten the two screws and lock
nuts to 105 in.-lb; then install the
seat and secure with the torx-head
screw. Tighten securely.
NOTE: On the LXR prior to lower-
ing and securing the seat, connect
the seat heater harness connector.
Fuses
Fuses protect the snowmobile electrical
system from overloading. If electrical
parts in the snowmobile are not working,
the system may have been overloaded and
caused a blown fuse. Before repairing or
replacing any electrical part, check the
appropriate fuses. If a fuse blows (opens a
circuit), all the parts of the snowmobile
that use that circuit will not work.
Once which fuse to check has been deter-
mined, perform the following steps:
1. Locate the fuse block and remove
the fuse block cover.
NOTE: Open the right-side access
panel; the fuse block is on the upper
spar.
PC020A
XM132
XM132
NOTE: There are spare fuses
beneath the fuse block cover.
2. Remove the suspected fuse.
NOTE: Fuse function descriptions
are next to the fuse contacts in the
fuse block.
3. Look through the clear side of the
fuse to see if the element inside is
burned or separated. If it is, the fuse is
blown and should be replaced with a
fuse of the correct amperage rating.
4. Install the fuse block cover and close
the access panel.
CAUTION
Connecting cables in reverse (posi-
tive to negative and negative to posi-
tive) can cause serious damage to
the electrical system.
! WARNING
Always replace a fuse with one hav-
ing the same specified amperage rat-
ing. Using a fuse with a higher rating
can cause severe wire damage and
could start a fire.
8000 Std
6000
8000 LXR
