7
When cold-starting the engine, the cool-
ant temperature warning icon and the
LOW TEMP display on the readout
screen will begin to flash. As the engine
warms, the TEMP display will continue
to flash, and the RPM “limit” of the
engine will increase. When the engine
reaches proper operating temperature, the
coolant temperature warning icon and the
LOW TEMP display will go out.
Speedometer/
Tachometer/Indicator
Icons
These snowmobiles are equipped with
different speedometer/tachometer styles.
Determine which style your model is
equipped with and use the appropriate
following information.
Standard Gauge
Certain models are equipped with a stan-
dard gauge combination speedometer/
tachometer. Indicator icons are incorpo-
rated within the speedometer/tachome-
ter. Also incorporated into the
speedometer/tachometer is a digital read-
out screen.
FZ003C
A. Low Oil
B. Coolant Temperature
C. Low Fuel
D. Fuel Level
E. Service
F. High Beam
RPM/MPH (kph)
By pushing the left button once, the RPM
and MPH will be displayed (one on the
readout screen and one with the needle).
By pushing the button once again, the
functions will be reversed.
By pushing the left button (with speed
being displayed) for more than two sec-
onds, the display will change between
standard mph or metric kph. Release the
button when desired display appears.
With RPM displayed on the readout
screen by pushing and holding the left
button, maximum RPM will be displayed
on the readout screen. The maximum
RPM readout will reset when the right
button is pushed (while maximum RPM
is displayed).
Odometer/Trip-Meter (1)/
Trip-Meter (2)/Hour-
Meter/Clock
NOTE: The clock is available on
electric start models only.
By pushing the right button, the readout
screen will display odometer, trip-meter
(1), trip-meter (2), hour-meter, and clock.
To reset the trip meter with the trip meter
displayed, push and hold the right button
until the display is cleared. The hour-
meter readout will not reset.
Clock (Electric Start)
With the clock selected on the readout
screen by pushing and holding the right
button for two seconds, the option of
selecting the 12-hour or 24-hour clock is
available. Push the left button for 12-hour
display; push the right button for 24-hour
display. At this point, the hours and min-
utes will begin to flash. Push the left but-
ton to change the hour display; push the
right button to change the minute display
(either tap the buttons for individual num-
ber display or push and hold the buttons
for rapid number display).
NOTE: During clock setting if nei-
ther button (left, right) is pushed
within a 5-second time period, the
clock-setting mode will be exited
with changes saved.