12
6000
8000
Handlebar Tilt (ZR/XF)
The handlebar can be adjusted to the
operator’s preference. To adjust the han-
dlebar, use the following procedure:
1. Remove the handlebar cover; then
loosen the eight cap screws securing
the handlebar caps to the riser and the
riser to the steering post.
0745-848
2. Adjust the handlebar to operator’s
desired position, tighten the cap
screws evenly to 15 ft-lb, and check
steering for maximum right/left
turning capabilities.
NOTE: Do not rotate the handlebar
to a position that allows air to enter
the brake system.
Code
Trouble
P0112 Intake air temp sensor 1 circuit low.
P0113 Intake air temp sensor 1 circuit high
P0117 Coolant temp sensor 1 circuit low.
P0118 Coolant temp sensor 1 circuit high.
P0122 Throttle position sensor circuit low.
P0123 Throttle position sensor circuit high.
P0261 Cylinder 1 injector circuit low.
P0264 Cylinder 2 injector circuit low.
P0324 Knock control system error.
P0327 Knock control 1 circuit low.
P0328 Knock control 2 circuit high.
P0351 Ignition coil (A) primary/secondary.
P0352 Ignition coil (B) primary/secondary.
P0545 Exhaust temp sensor circuit low.
P0546 Exhaust temp sensor circuit high.
P1000 Oil pump flow not programmed.
P1001 Injector 1 offset not programmed.
P1002 Injector 2 offset not programmed.
P1003 Oil pump outlier.
P1004 ISC outlier.
P1005 Regulator voltage circuit low.
P1006 Regulator voltage circuit high.
P1007 Fuel pump circuit low.
P1008 Fuel pump circuit high.
P1009 Speed sensor malfunction.
P1261 Injector circuit/open - Cylinder 1b.
P1264 Injector circuit/open - Cylinder 2b.
P1329 Knock sensor loose detection.
P1636 Crank angle sensor circuit.
P1639 Exhaust valve position sensor circuit
low.
P1640 Exhaust valve position sensor circuit
high.
P1645 Exhaust valve system malfunction.
P1646 Exhaust valve actuator self-cleaning
open error.
P1647 Exhaust valve actuator short error.
P1755 Engine RPM sensor circuit malfunc-
tion.
P2228 Barometric pressor sensor (A) circuit
low.
P2229 Barometric pressure sensor (A) cir-
cuit high.
P3001 Control module improper shutdown.
U1000 Vehicle not registered or invalid PIN
entered.
U1001 Vehicle not registered and vehicle lim-
its enabled.
U0155 Lost communication with the ECM
Code
Trouble
2
Failure in injector(s).
4
Open or short circuit in barometric pres-
sure sensor.
5
Open or short circuit in intake air tem-
perature sensor.
6
Open or short circuit in water tempera-
ture sensor.
7
Open or short circuit in throttle position
sensor.
12
Failure in ignition coil(s).
16
Incorrect adjustment/failure in APV
cable.
17
Failure in exhaust temperature sensor.
18
Failure in servomotor.
21
Open or short circuit in/or loose knock
sensor.
OCTN Low octane gasoline.
